34009 Parameter PRM: The parameter has not been found Gravure Japanese_Newspaper_OEM_Engine Lotem_400_Fiber_Head_Machine Lotem_800_Fiber_Head_Machine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 The group description was typed in correctly; however, the parameter description was mistyped. Ensure the parameter description was spelled correctly and try again. Try doing a listing of all parameter keys by using the 'prm read' monitor command. This command will show you all the parameter descriptions as well as all the group descriptions. If the parameter description does not show up under the specified group, then the parameter table has not registered with the PRM subsystem. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. The parameter description was mistyped in the monitor command prompt. The parameter was not registered. 08-JAN-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:00 2008 PST